DIY circular saw table.

   This is the time I had a need for a table circular saw. But the thing is, I didn't have the money for it. Nor the need I had was enough to convince me to spend the money I didn't have on this beautiful instrument.

   So I did what any reasonable man would have done. I built the damn thing myself, with materials I had on hand. And what I had was a circular saw, a jigsaw, PCB board and two pallets.

   The construction I thought of was not complicated. So I used a PCB board and cut a hole or a slit to be precise. This is where the saw is going through.
   The table was made by putting two pallets and screwing 4 planks in crisscross pattern for the stability with the table width of about 60cm.
   After that it was just a matter of screwing the hand circular saw to the pcb board, tying down the start button so the saw starts spinning when it is plugged into socket and there you go, ideal for small cuts and small projects.